Knock Sensor with Harness 12601822 12589867 Compatible with Chevy GMC Cadillac Yukon Tahoe Sierra Silverado Suburban Express 1500 2500 3500 Camaro Corvette Escalade

Per the GM bulletin, you will need to use RTV sealant to seal up these sensors. The rubber seals harden over time allowing moisture to gather in the sensor area and corroding the sensors. As suggested by some of the reviews, you may need to adjust the wiring a little bit so that the wires reach both sensors appropriately, honestly not a big deal.When removing the EGR pipe from the intake, it's a good idea to remove the pipe assembly. Even though it's a "flexible" pipe, the pipe may break due to age. This will cause a major vacuum leak if the pipe breaks between the EGR and the intake manifold.In my case, I ended up having to replace the EGR pipe assembly which also lead to replacing the exhaust manifold due to old age of the parts. Just be aware, my truck has 270k miles on the odometer and I ended up replacing both parts. It also lead to extracting some broken exhaust manifold bolts as well. I wish I knew these things before I tackled this project and had ordered the parts before hand.So far, no more knock sensor codes!

Didn't work, have to remove intake again and install genuine GM or Delphi.

These worked perfect for my problem. I had a check engine light because of bank 2. After careful installation, and sealing everything, my check engine light went away and has yet to come back and it's been 3 months. For the money, these are top notch sensors.

Had one knock sensor go bad -Rather than pull intake I screwed one of these into block at rear of right side above exhaust manifold and wired to connector.Simple tests with voltmeter ( ac) and knocking with screwdriver handle give about same readings.

Works like factory

Good quality parts

Drove the car for 60 miles and the knock sensor code came back that's just terrible

So far I've used these sensors twice and they have worked 1st try . Fingers crossed.