2Pack Power Adapter for Ring Stick Up Cam Battery(3rd Gen), with 30ft/9m Weatherproof Outdoor Cable Continuously Charge Your Camera, No Need to Change The Batteries

Received on time., excellent product.

These cords are great and long. I was able to go around my picture windows.

I purchased this power adapter for my ring stick up cam. I was constantly getting alerts and my battery was draining fast. My husband had to change the battery every few days. He installed the power adapter and it works great. We haven’t had to change the battery since then and It is a relief when I’m away for a few days and I can keep an eye on things without worrying about the battery draining.

These were a lot longer than necessary but that is my problem. They feel sturdy and i like that they come with little wall anchors to keep the cord in place. I would buy again for all my ring cameras

This product works as advertised and my batteries are now slowly charging.One bit of information that might be helpful to some: inside the single white wire are two smaller wires, red and black. I had to go through an interior wall to an exterior wall to deliver the power to my camera and did not want to drill a large hole to allow the weatherproof plug or the USB connector to pass through the interior and exterior walls. For anyone with basic wiring/electronics experience, it is a simple matter to cut the white cable somewhere in the middle, pass the white wire through a much smaller hole in your interior and exterior walls (3/16 or quarter of an inch) and rejoin the cable by reconnecting the black and red wires exposed by peeling back an inch or so of the white insulation.

I bought these because I was not impressed with the battery drain rate and motion detection polling interval of the battery-powered stickup cams. When you connect these power adapters the app thinks you have connected a solar panel, but after switching to hardwired mode (and bypassing the warning), the camera operates like I wanted it to and have zero power drain issues. The Ring website dashboard lets you see the battery % for cameras even when hardwired, so the ultimate test was when a spider built a web in front of one of my cameras overnight. The camera recorded nearly all night long and when I checked the battery - it was still sitting at 100%. Bottom line, this is a much cheaper option than the ring cable for getting your devices into hardwired mode.

Any Ring stick up camera or spotlight camera that runs off a battery and can accept Ring's solar panel charging cable will work with this. The cable will recharge the battery. The camera will not work with this without a battery in the camera. The cable recharges the battery, it cannot not directly power the camera. I have 2 spotlight cameras and 4 stickup cameras operating just fine. Just ignore some of the warning/alerts some older firmware might give you about the power mode you are in. If your settings show a charged battery and a solar panel connection, you are fine.

This kit is great! long cord and lots of hanger nails.I have been switching out batteries and wanted to hardwire, this kit worked perfect