Fender Flares Edge Trim, Fender Flare Rubber Seal for Car and Truck Wheel Wells, Rubber Gasket for Fender Flares Universal, Bonds w/Automotive-Grade Adhesive Tape, T-Style, 30’ Length

Good fit for 1st gen Tacoma

I see some reviews stating that the adhesive isn’t good or it sticks to itself and hard to peel of if it gets stuck to itself or it’s not self explanatory. There’s enough for all 4 fenders and there will be extra for 2 fenders just in case.1) just make sure the surface of adhesion is clean and dry2) as you are attaching the beginning, go slow, put pressure so it sticks well, don’t try to stretch it to save extra because at the end you’ll have places where it’ll come right off, as you move along you will slowly peel of the adhesion sticker.3) after installation if there’s small wavey areas just run your finger through the whole strip and it will flatten itself out and then cut off the excess.4) you gotta let it settle overnight and not let it get wet for maximum adhesion.

Nice product

Wooks great. As long as you clean the area with rubbing alcohol it sticks strong. Quality was better than expected.

the seal worked great! Better than expected.

Installed on fender but there is a gap between fender and truck....guess I should have bought OEM.

Nice and easy to work with.

bought this molding for a set of fender flares. adhesive didn't seem to stick, finally gave up and trimmed with silicon caulk. i cleaned the flares with alcohol before applying molding