CloudValley Webcam Cover Slide, 0.023in Camera Cover for Laptops, MacBook Pro, MacBook Air, iMac, iPad, PC/Computer, Tablets, Ultra-Thin Web Blocker Protecting Your Privacy [4-Pack]

Easy to apply, works great!

I chose this cover because iPads were listed. It has a bigger opening now where the camera is located. ONLY reading the instructions included, did it state there was a problem with some iPads!! Mine is only two years old. It would be NICE if they mentioned this in the description. They Obviously KNOW there is a problem.The first instruction: "Clean the edges of the webcam cover!" :-) I wondered... how did it get dirty? It is packaged and sealed! I think it should have read... clean the glass on the webcam where you are going to attach it. They use this transparent tape to put on the front to line it up and press and hold for a few seconds. That is nice. They don't ever instruct you to Remove the Blue tape covering the Back of the Camcover so it will Stick when you press and hold it a few seconds! You see that if you watch the video. Some people I know do not understand things like that unless explained.For those you cannot read their TINY TINY print. You are suppose to leave it for 24 hours before it is Fully Adhered. Many glues like this take 24 hours to set. Great for an average phone and smaller, older iPads perhaps. I feel they should have added more Details in their Description, and not in the instructions! Because it was a Waste of Money "for me."

I was thrilled to get these but they don't stick very well on the laptop. Several popped off and landed on the carpet, ruining the adhesive, so it's a good thing you get more than one per package!

It's very small and I can barely notice it which is amazing!!

Pros:- installs very fast and stays on well- manual camera blockage is the best way to know you aren’t showing your boss that it’s 2pm and you’re still in your PJs.Cons:- on my Surface Pro, the different sensors are very close to the camera, and even as small as these are, it was tough to put it on straight and ensure it wasn’t blocking anything.(Tip: I left the camera on while installing, and only peeled 1/2 of the backing away from the adhesion, until I had it placed where it wasn’t blocking).- it’s difficult to tell (because they are black, and so is the camera on my computers) whether the slider is blocking the camera or not at a glance. I fixed that with fine paint pens, coloring in the slider and the backing that shows when the camera is covered. So, when the camera is open, you only see the one dot. When it’s closed, you see the entire oval. You could just slide it to check, but these feel a little flimsy, and I didn’t want to mess with them that much.Overall, I’m happy with them. Cheap, easy, and they look nicer than my pink post it note covering them prior to these.

This is the third purchase of a webcam lens cover and it almost works perfectly. Is ultra thin and doesn’t seams to prevent the MacBook Air 2020 to close properly, but it does added a gap that worries me that could damage the screen since a gap indicates that pressure is concentrated in a spot. What makes it thicker seams to be the adhesion film as shown in the last picture. The sticking film added to the products makes it twice thicker.I also tried other magnetic version considering that should be thinner but the cover falls apart. So far seams to be a good product, made of metal. I wish it could be a little bigger to make it easier to slide, but not so big that it could interfere with the ambient light sensor usually at the right of the camera. It is a little bit hard to slide since is very small, but it might improve overtime while using. However is a good thing that it doesn’t slide on it’s own as reported by other versions of camera covers. If they can make the sticking part thinner the product will be perfect.

Installing the first one was a bit tricky, but after doing it once, I understood how to do it. The item works well!

Make it 4.5 stars, some of them definitely open easier and others. The one my PC works fine so I gave one to a friend and it just wouldn't stay closed. even I saw it open after folding the screen. I gave them another one and it works fine now.

The size is perfect for last generation of probook, elitebook and zbook (HP stopped to provide the shutters).The cover is so thin that it does not create any obstacles while closing the laptop (have tried plastic ones - definitely too thick).Worth the monet spent.

Fiddly to put on yet still quick and easy to do. Does the job and is not bulky so it doesn’t interfere when closing the laptop. Highly recommended.

I keep buying different phone camera covers like this but the but that slides across always falls off.The other part is so adhesive it pulls my screen protector off of my phone at the corner where I placed it.

Thin and easy to install, thoughtfully supplied with tape to help position which would otherwise be very fiddly to do.

Very handy, thanks.